RCU Forums - View Single Post - Conversion for non variable pitch rimfire
Thread: Conversion for non variable pitch rimfire
View Single Post
Old 07-14-2006 | 01:42 AM
  #4  
MikeBiv
Junior Member
My Feedback: (1)
 
Joined: Jul 2005
Posts: 8
Likes: 0
Received 0 Likes on 0 Posts
From: Longwood, FL
Default RE: Conversion for non variable pitch rimfire
What about the Mamo from Horizon Hobby? Will it fit?

http://www.horizonhobby.com/Products...?ProdID=MAOUSD

"it does not require a hollow shaft motor. It will include two set of blades 8" & 9" and will also be selling replacement parts. The most common to replace are (2) 2mm x 12mm screws that are sold by Du-bro in a pack of four."
MikeBiv is offline  
Reply Like