RCU Forums - View Single Post - Using a RotoZip bit in a Dremel for shaping a stack of ribs?
Thread
:
Using a RotoZip bit in a Dremel for shaping a stack of ribs?
View Single Post
08-17-2006 | 06:55 PM
#
1
build light
Senior Member
Joined:
Nov 2005
Posts:
2,246
Likes: 0
Received 2 Likes on
2 Posts
From:
Crete, NE
Using a RotoZip bit in a Dremel for shaping a stack of ribs?
I now have a router table atttachment for my Dremel tool.
Not having a bandsaw I was wondering if I might use a RotoZip spiral blade in my Dremel to aid in shaping a stack of ribs?
Robert
Reply
Like
build light
View Public Profile
Send a private message to build light
Find More Posts by build light
View iTrader Profile
Using a RotoZip bit in a Dremel for shaping a stack of ribs?