Sorry to switch a subject here, but I was unable to get a reply via PM from the mod's originator, so I'll try the open forum.

Those who have been to AA toolbox have seen the "slow turn mod." I can easily drive a soldering iron around a PCB, but I need a little clarification as to the wiring WRT what is going on UNDER the PCB. The pic shows the two diodes go through what looks to be drilled holes in the board.

On another matter, I am aware of the various throttle stick mods to increase the number of steps between low and high. Is there a way to simnply decrease the available "throttle" at the first step. My monowing modded AA still climbs a touch at low position. A hiar less would allow for level flight. It would be nice not to have to wire LEDs on them model just to decrease motor RPM.

Thanks for the help.

Ben Minor