I maidened that plane about an hour ago. Aside from the fact that the stock brushed motor isn't worth anything, it flew ok. My settings are as follows...

aileron +50%
elevator +50%
differential +0%

These are the defaults. I did have to reverse the servos though in programming for proper functionality. Like I said earlier, much ado about nothing. But I certainly appreciate all the responses. It's good to know that if it was more detailed than this, that I could get a little help (especially now that the local source of knowledge no longer exists).

At this point, I am shopping for a brusless setup for it as it is severely underpowered. I started a thread on it (in case anybody has any suggestions) to keep the board a little cleaner.
http://www.rcuniverse.com/forum/m_4843242/tm.htm

Thanks to all...