i'm off of 3d's yet, i can do stall turns or maybe few loops? i've just encounter another problem. i've setup my 7c to allow maximum (when i say max i mean it) throw for all the functions (aileron, elevator, pitch etc) without binding. when i fly in normal mode (hovering) i cannot get the high end of the pitch/throttle, when i go higher than per say, point 4, the motor stalls and my heli drops. maybe a new motor? it was fine a few flights ago, and as i said, i could make the blade cp 'jump'. but now, that just wont happen. in idle up 1 it's the same, in idle up 2 it's ok because i'm keeping the throttle at 100% at all 5 points, i hope it's the motor not the battery, i did have packed over 60 i'd say on that lipo pack (number of crashes). i brought it out to the field today and all i did were semi stall turns, i was gonna try my 6 loop today (crashed 2 out of 5 i've done so far). but seeing that teh headspeed decays soooo badly, i didnt do it.