Hi all,
I know theirs alot been talked about this sort of issue but here goes...
I need an aerofoil for an extra 300L, the model will be around the 100" mark and i'll primarily want a model that has a gentle predictable stall for snaps and spins. Secondly it should be good for 3D (this is where i need most of the advice)...i.e. a section that can be stalled predictably and will remain stalled easily (thats what i gather 3D capable aircraft to be doing).

Ok so what aerofoil....i would like to use the fiberclassics extra 330 foil for this but its an in-house special job!!

Any ideas...comments? :stupid: