Hey guys, I have a quick story for ya'll. I've been so busy lately and if I'm not busy it's to windy, so I haven't flown my Blade in a month. Any who I got a chance last week so I took it out. After reminding myself of all the dos and don'ts I took off. I could not get the tail to stop moveing around. I'd trim it right and it would go left and the same to the left, it would go right. It got hairy so I just went to forward flight and buzzed around a bit. When I got back into a hover it was way out of trim. I went back and forth until I lost control and almost hit my head. I duck down and it went over my back and hit the pavement. I was able to shove hard aileron in and right it on the skids after two or three blade strikes, not good on carbon. Today I fixed everything, tail boom, carbon blades, and my tail fin. I fired it up and the main shaft is slightly bent but not enough to replace. I checked my 4-1 settings and I had turned my gain all the way down in previous flights thinking that it was the proportional pot Back to basics in the set-up now, I can't believe I did that!

Cheers

Jay