this delta he bought has slide on wing panels. they bolt on from inside the fuselage. it has (i guess thats what their made of?) carbon support rods and a wing support tube. i've never seen a delta like that. he thought the wing panels had to be epoxied to the fuse. also the fit of the right wing panel to the fuse side was not good. something was not sguare, probably the root rib. i started to buy one of their .25 arfs but i thought $17.95 for standard ground shipping was somewhat extreme.
ORIGINAL: Hardin Valley Magic
Russell I couldn't agree more the directions, well, for lack of a better word, suck... Point blank. However The World Models had the Bipe set pdf and all I done was print them and at least I could read them. But it wasn't rocket science to put together. I was all covered, rather nice I shall say, and easy to figure what went where.
Hope he gets it flying and has a good time and forgets the bad step to get in the air...
