RCU Forums - View Single Post - ESC to Receiver
Thread: ESC to Receiver
View Single Post
Old 11-12-2006 | 10:45 AM
  #1  
benbailey50
Junior Member
 
Joined: Oct 2006
Posts: 18
Likes: 0
Received 0 Likes on 0 Posts
From: Durham, NC
Default ESC to Receiver
Looking for an answer to a problem....[&o]

New to Electric Flight....[X(]

Unable to get motor to run.... E-flite 25-Amp Pro Brushless ESC.... Futaba Receiver R114F. On the receiver they say that Ch4-Batt. Then Ch3 is throttle on the ESC leads. Unable to figure this one out. As the leads on the ESC have not guide to fit into the receiver for correct orientation.
benbailey50 is offline  
Reply Like