RCU Forums - View Single Post - Official HPI MT2 Thread
View Single Post
Old 11-15-2006 | 08:10 PM
  #8945  
bradley_wrench's Avatar
bradley_wrench
Senior Member
 
Joined: May 2005
Posts: 173
Likes: 0
Received 0 Likes on 0 Posts
From: apo, AE
Default RE: Official HPI MT2 Thread

maybe you are priming too much fuel into it before you try starting it. Pull your glowplug and give it a few pulls, then put it back in and try to start it without priming.
ORIGINAL: crohbober

my engine seizes up when i tried to start it before do u know why. is there any hope for saving it?