First of all, I want to thank everyone who have offered their assistance, pictures, and tips. I would not have even attempted this build without you.

For the first part of this build I started with the center section of the main wing spar.

I started this build by studying the plans.
Then I removed the laser cut short wood kit cut by Bob Holman. The wood was excellent! Very well cut - clean, straight, etc. Thanks for all your help Bob!
Then next step was studying the plans.
Then I sorted the wood according to major sections - center section, wing, control surfaces, fuselage, etc
The next step was to study the plans.
The next step was to post questions to this forum about the plans!!!
After studying the plans and reviewing the comments and pictures from others here on RCU I laid out the center section pieces onto the plans.

Picture Zx71053 shows the middle pieces
Picture Pk30914 shows the center section of the wings
Picture Af90289, Zt52108 and Gr93925 shows the front and rear main spars with ribs in place. They are (left to right) attached as 2 - 1 - 2.
The piece is placed on the plan for reference..


Two #1 ribs were in the kit. Anyone know why?