RCU Forums - View Single Post - Lathe for conversions
View Single Post
Old 12-08-2006, 01:34 AM
  #161  
Volfy
Senior Member
My Feedback: (23)
 
Volfy's Avatar
 
Join Date: Jan 2002
Location: Houston, TX
Posts: 3,227
Likes: 0
Received 0 Likes on 0 Posts
Default RE: Lathe for conversions

Captin, thanks for the note. I do try to be very careful moving them around. I'll remember to pull more than push. The big mill is bolted to the stand and to the wooden base. The others will soon be bolted through the table top.

Speaking of northern country, I do miss it sometimes - especially the fall foliage. Well... only sometimes. I lived up there in CT and NY through most of the 80's and early 90s and remember the snow, slush and salt. Can't decide if that's better or worse than the mosquitos, mugginess and mold down here. Oh well, you win some and you lose some.