RCU Forums - View Single Post - Lathe for conversions
Thread: Lathe for conversions
View Single Post
Old 12-09-2006, 12:41 PM
  #166  
Mike@Accurate
Senior Member
 
Join Date: Jan 2005
Location: , DE
Posts: 112
Likes: 0
Received 0 Likes on 0 Posts
Default RE: Lathe for conversions
Cap'n, the big wheel moves the apron(?) left/right through the rack and pinion gears. So long as the travel needed is less than the travel of the compound, it would probably make a better finish than the rack. Good luck, MIKE
Mike@Accurate is offline  
Reply Like