Hello Everyone, I recently purchased a Super Tigre GS-40 for my Eagle II trainer. Today I started
to break the motor in. I followed the instructions completey, it took a few minutes to start but it did start and ran continuously for the whole 10 oz tank I followed the break in procedure putting it in full throttle for 5 minutes then doing the pinch test and 1/8th turn on the high speed needle to start leaning the motor outyou know the whole process. This went BEAUTIFULLY and the motor ran strong the whole time i ran it but as soon as the first tank was out i turned it off and refilled the tank to continue tuning/breaking in the motor, well the motor would not start at all and i had to put the needle settings back at square one and go back through the steps to only have it happen again on the next tank I dont no why it wont start right up after tuning it, im running 5% omega fuel in it the LHS said it was all i needed. Please help I want to get the motor tuned so i can learn how to fly.