RCU Forums - View Single Post - Lathe for conversions
Thread
:
Lathe for conversions
View Single Post
12-11-2006, 01:05 PM
#
171
captinjohn
Join Date: Jan 2002
Location: Hesperia Michigan, MI
Posts: 12,957
Likes: 15
Received 4 Likes on
4 Posts
RE: Lathe for conversions
OK....but by looking at the photo...which way do I need to move the rear of motor. Would it be up or down? My guess is up...but some may know for sure. Guess I will move it again, but have not had any luck yet! Capt.n[:-]
Reply
Like
captinjohn
View Public Profile
Send a private message to captinjohn
Find More Posts by captinjohn
View iTrader Profile