RCU Forums - View Single Post - CX2 upper head question
Thread: CX2 upper head question
View Single Post
Old 12-21-2006 | 12:26 AM
  #1  
dankirk's Avatar
dankirk
Member
 
Joined: Dec 2006
Posts: 39
Likes: 0
Received 0 Likes on 0 Posts
From: Plumas Lake, CA
Default CX2 upper head question
Hello,

Should there be any gap at all between the upper blade mount and the upper bearing? Or, should the upper mount be held tight against the bearing holder with no up/down play at all?

Thanks, Dan
dankirk is offline  
Reply Like