I found it only to be a problem when the elevator rates were set to high. I was messing around with one of our more experienced pilots. I had my elevator on high rates higher then recomended. got to low turn to go after him and OOPs. Re kit. I forgot I was on high rates. when I had it set to low rates it would never snap out I took it up nice and high and it was fine. full up no problem. I had the elevator set for higher rates for doing inverted flat spins where I needed alot of down elevator to keep it upside down and spinning. I've got the new one already if I get time this weekend I'll build it. Great little Plane. I run a super tiger 90 in it with a Macs shorte pipe.