this is for suwerdude about the trow in inches:
---------low rate --------- 3D
aileron is: 1" ------- 3¼" up and down
elevator is: 1" ---------- 4¼" up
1 1/8" -------- 4 5/16 down
Rudder is: 2 5/8" -------- 5 9/16" left and right

I did my own mitter with autocad 2006 by desingnieg a radius of the parts and place degrees on that radius print them on paper, glued to a card board then fix it to a dowel stand, placing them in center of the part to be adjust. may be it's too late but if it can help someone else .It's free anyway. Would like to insert photo but don't know how.