RCU Forums - View Single Post - 2 servos on one surface 9zap
Thread: 2 servos on one surface 9zap
View Single Post
Old 02-04-2003, 06:43 PM
  #17  
mecam
Senior Member
My Feedback: (3)
 
mecam's Avatar
 
Join Date: May 2002
Location: Airfield, CA
Posts: 559
Likes: 0
Received 0 Likes on 0 Posts
Default 2 servos on one surface 9zap
Nevermind, I got it. I should have read the whole post before I opened my mouth. I have been using FNC where I should have been using P-MIX. Mix rudder as master and ch7 as slave and turn trim on. DAMN!!! I wasted $60 on this damn Matchbox.
mecam is offline  
Reply Like