RCU Forums - View Single Post - Proper linkage setup on blade CX?
Thread: Proper linkage setup on blade CX?
View Single Post
Old 01-11-2007 | 01:55 PM
  #5  
whtmex
Senior Member
 
Joined: Jan 2007
Posts: 153
Likes: 0
Received 0 Likes on 0 Posts
From: spring hill, FL
Default RE: Proper linkage setup on blade CX?
With the Trans. and reciever on, make sure throttle is full off, and all other controls and trims are centered. adjust the servo rods so the swashplate is at a 90 deg angle from the main shaft on all sides.
whtmex is offline  
Reply Like