RCU Forums - View Single Post - Proper linkage setup on blade CX?
Thread: Proper linkage setup on blade CX?
View Single Post
Old 01-12-2007 | 07:26 PM
  #15  
bzinfinity's Avatar
bzinfinity
Senior Member
 
Joined: Oct 2006
Posts: 872
Likes: 0
Received 0 Likes on 0 Posts
From: Savannah, GA
Default RE: Proper linkage setup on blade CX?
Flybar linkage will change the tracking of the upper blade.

You only need to move this if you notice that the uppers are not tracking in the same plane during hover.

Bryan
bzinfinity is offline  
Reply Like