RCU Forums - View Single Post - CG- Measuring in. to cm.
Thread: CG- Measuring in. to cm.
View Single Post
Old 01-26-2007 | 11:39 AM
  #4  
RealPilotAce
Member
 
Joined: Jul 2006
Posts: 70
Likes: 0
Received 0 Likes on 0 Posts
From: Enfield, CT
Default RE: CG- Measuring in. to cm.
That was what the '~' was for about. But thanks for the exact measurement. I'm going to go a bit nose heavy, 1 cm. Which would work out to the 3.75 or so, Just to see how it will take to the air. Then make any changes afterwards.

I wish I could find my metal machinist ruler.
RealPilotAce is offline  
Reply Like