Thanks for the reply. This engine is used and is already broke in as it was used before it went into the cap. I haven't tried leaning it out on the low speed yet but I can't believe that the amount of crank runout I measured is factory or acceptable. I think .002 tir would be bad enough let alone .020. With everyone using CNC equipment they should be to hold this to .001 tir or better easily. I need to fix it or get my money back so holding out for the new motor isn't an option. What is included in the upgrade? Is that price just the parts or is that the price sent to BME. I wish BME would answer the phone.

Thanks again. Rick