RCU Forums - View Single Post - 3D Foamy Advantage Bipe - build thread
View Single Post
Old 02-07-2007 | 09:03 AM
  #54  
WhtBronco's Avatar
WhtBronco
Senior Member
 
Joined: Oct 2002
Posts: 2,084
Likes: 0
Received 0 Likes on 0 Posts
From: Winchester, VA
Default RE: 3D Foamy Advantage Bipe - build thread

I've decided to set up the motor with no right thrust. A lot of park flyers are that way now with little effect. I can always shim it later if need be.

The ailerons are done, the elevator is done, the motor and ESC are installed. I just have to pick a spot for the Rx and get the rudder servo setup.

Depending on the weather and how I'm feeling I hope to fly it this weekend. I don't care if it's cold(I like it cold), but I prefer fairly calm winds for a maiden flight. Also I currently have a broken vertebrae, T1(located at the baase of the neck). Somedays I'm okay and somedays, like today, I can barely move my head.

I do like it really cold too. Today the temp was 16 when I left the house and I kept the window on my truck open for almost the entire 2 hour ride to work. Anything over 80 and I stay inside though, I don't do heat it just makes me sick. I wish the li-po's liked the cold better, LOL.