RCU Forums - View Single Post - problem- too much down trim required
Thread: problem- too much down trim required
View Single Post
Old 02-08-2003 | 02:22 PM
  #3  
Dsegal
Senior Member
 
Joined: Oct 2002
Posts: 2,065
Likes: 0
Received 0 Likes on 0 Posts
From: Philadelphia, PA
Default problem- too much down trim required
That 1/8" shim sounds a little drastic. I would try a 1/32" shim first and then a 1/16" shim.

Dave Segal
Dsegal is offline  
Reply Like