RCU Forums - View Single Post - Thrust Required For 2M Pattern?
Thread
:
Thrust Required For 2M Pattern?
View Single Post
02-22-2007 | 12:42 AM
#
21
patternflyer1
My Feedback: (
11
)
Joined:
Jul 2003
Posts:
2,080
Likes: 0
Received 0 Likes on 0 Posts
From:
Tracy, CA
RE: Thrust Required For 2M Pattern?
I think with the Axi 5330/F3A we are pulling about 5800 rpm with a 22x12. I haven't checked in quite some time though. But I did pull this off a thread that we had. Sick power!!!!!!
Reply
Like
patternflyer1
View Public Profile
Send a private message to patternflyer1
Visit patternflyer1's homepage!
Find More Posts by patternflyer1
View iTrader Profile
RE: Thrust Required For 2M Pattern?