Hello everyone, I am almost finished with my gp rv-4 on the whole I have been impressed with this kit. My kit did however; have a few parts where the die cutting was not very good, and the cowling cut lines are not very good<i am going to have to be very careful with that.> I also think that the wings center section is a tad bit more involved than it needs to be. I am going to put an os 46 fx with on board ignition on mine and the flaps are going to be installed.

I am debating on the idea of fiberglassing the plane but I am not sure about this do you have any ideas or suggestions on this.