I've had my Axe for a couple weeks now, been through a dozen LiPo TP 1320 packs or so, and, luckily, NO CRASHES!!! [8D]

I got her working good with my DX6 radio gear!! [>:]

I have got the hover down pat, but need a good amount of room. If she starts to go in a direction pretty good, then I need a good 5 or 6 feet to get her going back to center.

I've been playing with the main rotor speed at hover and its pretty good now. On the slow side even, possibly. May drop it further to see what it does, BUT my next move now is to adjust the Tail Trim pot on the stock 3-in-1 board.

I was hoping to avoid altering the factory settings but she yaws too much to the left. Its too much effort to keep pressure on right rudder - its keeping me from getting better, so I gotta adjust it.

When I get it dialed in, I'll post up my DX6 settings. I think I'll need to call in an expert to finally verify my rotor speed and collective curves are good.