RCU Forums - View Single Post - axe cp thread
Thread: axe cp thread
View Single Post
Old 03-07-2007 | 05:20 PM
  #318  
[]TEX[]
 
Joined: Jun 2006
Posts: 9,967
Likes: 0
Received 0 Likes on 0 Posts
From: Glenview, IL
Default RE: axe cp thread
When I get mine set up I will have better information for you on this.

Setting gain for hover is fine, but once you get into FF you will need to lower the gain setting.

If your 3-1 board is defective call tower.
[]TEX[] is offline  
Reply Like