Did some hover practice in the garage tonight. I'm makeing steady progress and getting higher each time.
One thing I noticed is that the tail occilates terribly when I get off the ground after a couple seconds.
This may have been there since day one since this is the first time I've had it airborne for more than a few seconds.
Should I try reducing gyro gain?
It says the heli should remain stationary until the gyro initializes, but it's darn near impossible to plug in the battery without jarring it a little. Could this be my problem? I set it on blocks when I plug it in so the training gear doesnt cause it to bounce, but it still get's jarred slightly.
I did by a blade cp tailrotor today, and noticed it was ever so slightly looser fitting than the axe cp tailrotor. I'm starting to think it could be throwing it out of balance.
It's not the tail twitch everyone is talking about, but occilating up and down as well as left and right.