RCU Forums - View Single Post - axe cp thread
View Single Post
Old 03-15-2007 | 09:03 AM
  #483  
Gamemaker
Member
 
Joined: Jan 2007
Posts: 68
Likes: 0
Received 0 Likes on 0 Posts
From: Chesapeake, VA
Default RE: axe cp thread


ORIGINAL: chaseman81

It should take 10 seconds before moving the heli so the gyro can stabilize my light only stays on for a few of those ten seconds. But comes on right away after plugging in the batt.

Chaseman81

SchoooBak look for one of those $23.99 lipos 11.1v 1200 -1300MAh because they are making them better all the time the older ones are getting cheaper to buy. You will get a whole lot more time when you get outside with one of those. 12-15 min.

MY TP11.1v 1320MAh cost me about 57. with the Mini plug for the AXE CP heli about month and a half ago LHS and I don't have a balancer yet I use the ICE charger very nice. I have it set for 11.1v lipo 1.3A because that is as close to 1320 as i can get. Just be careful not to over charge the li-po batt. I charge mine in a big cooking pot with a lid and never leave it alone while charging.

Anyone using Li-pos due yourself a favor and watch this video (it could save your house!)
http://www.helihobby.com/videos/LithiumBattery.wmv
ok charge at 1.3A without a balancer bad idea if one gets to high boom charge at .5A till you get a balancer