mnmills2

I am building a sig king kobra. I am almost done and ready to cover. I sheeted the wings and used a contact cement to join the sheeting and foam. Well, I took my plane I was so proud of over to a friends to show him. Not thinking, I left the wing in my car and went to work the next day. Well...it got hot and the foam expanded just a little. Enough to break the sheeting free from the foam in the middle of the wing in a couple places. any ideas on how to get those spots to glue back down? I have installed retracts, thus I have spent countless hours on the wing and I am not too excited about starting over. I was toying around with the idea of a syrenge full of glue with a needle....but figure I better look for some experience first.

Thanks,
Mike