RCU Forums - View Single Post - Wheeeeeeee.......... Blade CP!
Thread: Wheeeeeeee.......... Blade CP!
View Single Post
Old 03-26-2007 | 05:41 PM
  #1492  
crashcrash
Senior Member
 
Joined: Nov 2006
Posts: 6,073
Likes: 0
Received 0 Likes on 0 Posts
From: St Louis, MI
Default RE: Wheeeeeeee.......... Blade CP!
Someone bring this man a bucket and a stool....he's milking the heck out of this job.
ORIGINAL: choppersrule

Choppersrule Here:

Update on my Rebuild with brushless motor and G90 gyro..
See pictures,,, Over a week and this is all I have done, just been busy..
Got the main frame, tail boom, tail housing put together, Ran the wires for the tail rotor, and made sure I installed the upper and lower bearings in the main frame and the two bearings in the tail.. Not much progress at all.

Dave / Choppersrule
crashcrash is offline  
Reply Like