If anyone can score me a SCHEMATIC for the stock 3-in-1 board I would love to do a little circuit analysis.

Where I am at:

Looking really good actually, and ready for more forward flight and gentle pattern flying, dead calm weather permitting. I am still trying to fine tune the tail, still have a slight 'twitch' which I may downgrade in description to a 'short repeated wag'. It is not much of a problem to deal with.

Still, my DX6 right rudder trim is around 30 points to the right - but since she hovers well I am thinking this is ok.

Need help:


I tried playing with the REVO-MIX settings - there is RVU and RVD, which seem to be associated with the Throttle Hold Switch (upper right switch), where RVU is "Switch is Up" and RVD is "Switch is Down".

These settings go from + / - 125%. I could not figure out if they could help - but they can certainly disable the tail from going one direction or the other.

Tips anyone?


Gyro Help:

After I dial in the tail, I want to get a HH gyro going. But, it looks like I must also buy a separate ESC for the Tail Motor? Or?? Can I have the stock everything and just add the GY201?