rickbarr Or BARRICK, here with an honest to goodness request for help.

I REALLY NEED to be able to install the heat sink in my CX2... nothing has happened so it's not an urgency,
BUT .... As IGNORANT as I can be : I am unable to figure out how to remove the landing setup and even the red canopy.
Would somebody STEP ME THROUGH this process ?
it was clearly explained to me before, here in the thread, how easy it is to do : but UNLESS I remove the body and the LG I can't reach the one screw holding the motor. are all these plastic items GLUED together ? the struts don't want to come out, pulling so hard will rip up the body, etc etc

see ? TOLD YA AM REAL STOOPID, DUH !