RCU Forums - View Single Post - axe cp thread
View Single Post
Old 04-08-2007 | 08:11 PM
  #660  
Rotor13B
Senior Member
 
Joined: May 2003
Posts: 253
Likes: 0
Received 0 Likes on 0 Posts
From: Co
Default RE: axe cp thread

Really? My Nexus will sit in a hover with very little input from the radio. Maybe that's why it was easier for me to putz it around the field than the Axe. The Axe is all over the place for me when i'm hovering it even though I can keep it in the air. If I start doing circuits though it's flys ok. I had to send it in for servicing though because I think it had a defective receiver in it.