Hi Guys,

I've been reading the forum for some time and have picked up lots of useful info, but this is my first post and I'm looking for recommendations.

I'm the proud owner of an X-Cell Gas and this is my first experience of using gas motors with RC. I plan to use this helicopter at long range for photographic work but I'm very concerned about electronic noise causing interference leading to the loss of my pride and joy.

So here's the question.....

What electronic shielding (products, procedures and methods) would you guys recommend for protecting the RC gear against unwanted electronic noise?

I'm really looking at implementing a full "belt and braces" approach here as weight gain is not too much of an issue.

Thanks in advance

BladeSlap