Ok, guys here is my problem I bought the axe cp and crashed it couldn't get parts from the world of hobbies retail store where I purchased ...in frustration I bought another axe from another hobby shop ....so far so good, but out of the box these things run like crap ....very hard to trim like nobody did any real test before putting it in a box. The guys at world of hobbies said nothing of it needing some tlc setup before trying to fly it but after I brought it back in for parts they were very willing to volunteer their services to he tune of $125 to do a setup. The guy said my main rotor shaft was bent so I spent money on parts not to mention a teardown for repair and it turns out all it was was an unbalenced set of rotor blades. well after I put this first heli back together it won't trim on the left and right rotor control ...turns out the potentiometer oon the e-board is not there ??? fell off a new e-board costs 85 bucks half the price of a complete new heli F- THIS I am sick of forking over money .....also on the other heli the tail rotor motor screws strip out like instantly and or get loose .....*** a 200 dollar heli is turning out to be a complete money pit. I am ready to sell everything I have invested for $400 bucks after investing a lil over $600 this blows! Does anyone have any ideas or advice ...did I just buy junk or what ? a hobby should not be this stressfull it isn't all about the money it's the frustration of buying something and it's ****! HELP!