RCU Forums - View Single Post - Neutralizing servos?
Thread: Neutralizing servos?
View Single Post
Old 05-09-2007 | 11:31 AM
  #1  
foosball_movie's Avatar
foosball_movie
Senior Member
 
Joined: Jan 2007
Posts: 432
Likes: 0
Received 0 Likes on 0 Posts
From: Denton, TX
Default Neutralizing servos?
What's the proper procedure to neutralize a servo? I'm installing the control rods on a Venture 60 and the instructions state I should neutralize each servo before completing the rods.
foosball_movie is offline  
Reply Like