RCU Forums - View Single Post - Neutralizing servos?
Thread: Neutralizing servos?
View Single Post
Old 05-09-2007 | 07:34 PM
  #8  
Sneasle
Senior Member
 
Joined: Jan 2006
Posts: 1,164
Likes: 0
Received 0 Likes on 0 Posts
From: Talladega, AL
Default RE: Neutralizing servos?

ORIGINAL: jetmech05

I agree with what everyone said except no one mentioned to make sure your trims are at neutral also.

That was actually mentioned earlier with the term "sub trim" in the second post.
Sneasle is offline  
Reply Like