RCU Forums - View Single Post - Break in needle settings.. engine acting funny
Old 02-26-2003 | 05:55 AM
  #1  
BUGGIES_R_US's Avatar
BUGGIES_R_US
 
Joined: Dec 2002
Posts: 3,342
Likes: 0
Received 0 Likes on 0 Posts
From: Norcross, GA
Default Break in needle settings.. engine acting funny

Well heck I'm on my.. like 4th or 5th tank now with my Rossi?

Now I God know where my LSN/mid and HSN are I gotta reset them..

But I'm trying to lean it, but it still stays stone cold.. around 125 lol

I turned the hsn in 1/2 and the LSN in 1/4.. still nothing

Oh.. the problem.. I only have the throttle set at a max at 35%.. but when I close to "floor" it.. the RPMS go down as if the engine is bogged down by too much fuel... of course its smoking a lot..

I'm almost sure its running way too rich.. the temp readings I got right after a run were as low as 89 degrees! lol

I'm gonna reset my needles again tomorrow.. any other suggestions?

ram