RCU Forums - View Single Post - Adjusting the prop shaft angle via radio/servo
Thread: Adjusting the prop shaft angle via radio/servo
View Single Post
Old 05-19-2007 | 01:02 PM
  #1  
SpartacusII
Junior Member
 
Joined: May 2007
Posts: 15
Likes: 0
Received 0 Likes on 0 Posts
From: cambridge, UNITED KINGDOM
Default Adjusting the prop shaft angle via radio/servo
Is there any tunnel hull modellers who have used a system to adjust the prop shaft angle during a run, if so are there any details about. Thank you anyone...
SpartacusII is offline  
Reply Like