RCU Forums - View Single Post - acceptable hinge gap
Thread: acceptable hinge gap
View Single Post
Old 02-27-2003 | 03:08 PM
  #5  
visioneer_one
My Feedback: (506)
 
Joined: Dec 2001
Posts: 2,429
Likes: 0
Received 0 Likes on 0 Posts
From: St. Thomas, VIRGIN ISLANDS (USA)
Default acceptable hinge gap
I agree with Geistware. I recommend sealing the gaps on *both* sides with strips of clear monokote. Standard clear ultracote is a little too stiff for this application, and lite clear ultrakote is a little too btirrle.
visioneer_one is offline  
Reply Like