RCU Forums - View Single Post - engine / pipe question
Thread: engine / pipe question
View Single Post
Old 05-21-2007 | 04:15 AM
  #6  
amec
Senior Member
 
Joined: Jun 2005
Posts: 719
Likes: 0
Received 0 Likes on 0 Posts
From: wamberal, AUSTRALIA
Default RE: engine / pipe question
How many rpm is your drill spinning at? Probably printed on the side of it. My drill spinning at 1300rpm would do it until the volts dropped, then not.
Some drills just cant do it.
amec is offline  
Reply Like