RCU Forums - View Single Post - engine / pipe question
View Single Post
Old 05-22-2007 | 03:24 PM
  #17  
11039078
Member
 
Joined: May 2005
Posts: 56
Likes: 0
Received 0 Likes on 0 Posts
From: Donton
Default RE: engine / pipe question

well. the savage certainly starts better with the new fuel (although it did take a good hr of turning over befor it acepted the new fuel lol).

But...(thers always one! ) at first if i got past half throttle, it just cut out. All needles are at factory setting by the way.
So i fidled a bit and left it to just idle for half a tank (a. so it could warm up b. so it could flush out all the old fuel and run the new fuel in). i picked it up, held the gas and it just screached, it sounded extremly Lean. i then noticed that the exhaust was hanging off!!![X(]

wether it was the exhaust causing it to run like that of not is beyond me but it was definaly not right. it acelerated and acelerated and acelerated, and had no sighn of stopping.

Also, i have to have he trim rite the way up for it to idle without dying (so wheels are spinning quickly). And that doesn't change after it gets warm either.