RCU Forums - View Single Post - Cutting fuselage for needle valve?
Thread: Cutting fuselage for needle valve?
View Single Post
Old 06-02-2007 | 06:44 PM
  #1  
Gstan
Senior Member
 
Joined: Dec 2003
Posts: 111
Likes: 0
Received 0 Likes on 0 Posts
From: detroit, ME,
Default Cutting fuselage for needle valve?
I have a 4*40 and I’m mounting a Saito 72 on it. I have to turn the carb around for my pushrod to control the throttle. Now my needle valve will hit.
So first of all, what is the best method to cut the plywood? And second, what is the best look? Trim the whole side down or just cut out a circle.
Any pictures would help.
Gstan is offline  
Reply Like