RE: drdoom enhine fit
Rodmad,
I noticed H9 quality control is slipping a little too. Specially with the Rudder tiller arm. Be sure to take your time and test before epoxing.
I had to pull my out and start over. In my kit, they should have made the tiller arm about 3/4" longer to fit properly as the manual states.
I built mine with a Zenoah G26, and found their measurements were a little off with the installation of the motor. I had to make the spacers approximately 1/4" longer for the spinner hub to clear the front of the cowling.
How is your coming along?
Fly 'em hight, land 'em softly
Yakflyer