Took the Bobcat with P-60 out to fly today. Start-up was normal and engine responded normally during 7 minute flight. After landing, plugged in the GSU for shutdown and got --Err-- where the temp is displayed. Ran the engine up to full throttle and temp showed 1148 C. Obviously something wrong with temp sensor, at 1148 C there'd be liquid parts dribbling out the back end. Shut down the engine and cucled power to the ECU and RX. Turned everything back on and got "Temp Sense Fail". Did the temp sensor calibration proceedure and after it ran got "Temp Sense Fail - Cable amp".

What do I need to do to fix?