RCU Forums - View Single Post - New PAW .40 running lean at idle
View Single Post
Old 06-15-2007 | 09:34 PM
  #9  
carterwlsn
Junior Member
My Feedback: (2)
 
Joined: Nov 2002
Posts: 7
Likes: 0
Received 0 Likes on 0 Posts
From: Gardendale, AL
Default RE: New PAW .40 running lean at idle

I tried to fix my idle problem again this afternoon without success. I wonder if my fuel tank could be too low? It is about 1/2 '' lower than the carb. I am going to try a diffrent carb off of my old, worn out PAW. If that dosn't work, I might try to make the air bleed hole smaller to enrichen the air-fuel mixture. Here is a video I shot this afternoon of the engine running.
[link]http://www.rcuvideos.com/item/XNNW20BQBHVB9XFN[/link]