hey guys, i guess i down with the fishes when it comes to experience with rc cars... but i have one critical question regarding rc drift tires.... so basically i got some bare rims (w/o rubber tires) and pvc tubing... after an exausting effort in cutting and filing down the pvc pipe, i realized that the pipe is way to thin, to a point where my already low TT-01 chassis would not have enough ground clearance to run on anything but a clean gym floor (which i dont have access to)... im wondering if this is how its sopposed to be, or should i get a larger diameter pvc pipe and fit it onto a wheel that already has the rubber tire? (but then would the diameter be so large that it would rub on the body/front bumber/car body when turning?)

i realise this thread has been dead since april... so any kind of response is greatly appreciated